Bell and Howell Truper 3200 Cleaning Manual

8, 3 Cleaning the Scanner S006881 8 of 7 3 Cleaning the Scanner When scanning mostly NCR™ type paper, Böwe Bell + Howell recommends cleaning the scanner at a minimum, every 1000 scans or once per week, whichever comes first. In the event the scanning of NCR™ type paper occur…

12, 3 Cleaning the Scanner S006881 12 of 7 Note: Drive rollers are located in the front and rear ADF as illustrated below 6. After cleaning the residue off the rollers apply Tire Roller Cleaner (S003410) to a she…

7, Cleaning Guide for NCR™ Type Paper Residue S006881 7 of 7 Inspecting the scanner Caution Before you begin, please make sure scanner is powered off and the power cable is disconnected from the back of the scanner Before starting it is necessary to inspect the scanner and roller…

14, Bell and Howell Truper 3200 3 Cleaning the Scanner S006881 14 of 7 3.3 Cleaning the Front ADF (Exit) Section To clean the front ADF (Exit) section, perform the following: 1 Lift or fold the Hopper Tray to its upright position (see image below) Pull the Exit Door Release handle towards you to r…

5, Cleaning Guide for NCR™ Type Paper Residue S006881 5 of 7 Caution Without the proper cleaning the issue as described in Scanning NCR™ Type Paper may cause serious problems to the scanner’s rollers which can lead to frequent scanning issues. 2 Getting Started …

6, 3 Cleaning the Scanner S006881 6 of 7 Materials Needed • NCR Cleaning Kit (S006880) Note Items labeled “Not Supplied” in the list below are without part numbers they are necessary but are not provided in the cleaning kit, it is the responsibility of the user to obt…