RADWAG PS Series Operation & User’s Manual

53, 53 OP1 WILK (operator1 WILK) An instance of a user name inserted to a balance using small letters takes below form: Op1 wilk (operator 1 wilk) • P2.2 PrJ The parameter enables determining name of a project (e.g. related to a specific type of weighing process)…

81, 81 16.4. Format of data sending Weighing result can be sent to a peripheral device by pressing PRINT key on a balance keyboard or by setting a control command from computer level. 16.5. Format of data sent on pressing of PRINT key Depending on setting of P4.5 PStb parameter on…

46, 46 12.3. Adjustment test 12.3.1. Balances with internal adjustment Adjustment test is a comparison of internal adjusting weight with its value stored in balance’s memory. This process is automatic and its result is shown on the display (if a balance is connected to …

84, 84 18. LIST OF COMMANDS COMPUTER – BALANCE • Function TARE Command T CR LF (balance tarring) • Function ZERO Command Z CR LF (balance zeroing) • Function IMMEDIATELY SEND WEIGHING RESULT IN BASIC MEASURING UNIT Command SI CR LF (immediat…

29, 29 10. BALANCE MAIN PARAMETERS It is possible to adjust balance’s operation to ambient conditions at a workstation (by setting filter range and value release parameters) or user requirements (autozero settings, last digit visibility). These parameters are set in group &l…

50, RADWAG PS Series 50 12.5. Adjustment report printout On completion of any type of adjustment process, the balance enables preparing a report from adjustment process. The report can be printed on a connected printer and sent to a computer and saved in a form of file for records. Print…