RAM 3.0 BUX II Series Operation Manual

7, RAM 3.0 BUX II Series The Power switch must always be on the “Off” position before plugging the amp to a properly earthed mains soc- ket (220-240V AC). The input signal fed to the amplifier can be either balanced or un-balanced. The drawing below describes both ways to wire an XLR connector for the purpose…

8, Installation and Operation Installation et mise en service The amplifier can operate on three diffe- rent configurations: DUAL, BRIDGE or PARALLEL. The connections for the three modes are different. See Figure - Switch “Off” the amp. - Set the Mode Switch on the rear panel to “DUAL”. - Conn…

4, The RAM ® BUX Series Power Amps have been developped to meet the hig- hest goals in the field of professional power amplification. Their power, distor- tion and dynamics figures place them as reference in the industry. The BUX Series incorporate unique Absolute Protection Systems as th…

11, 4.1 Data 4.1 Données techniques4.1 Technische Daten Technical Specifications Spécifications Tecnische Spezifikationen 10 Technical Specifications BUX-2.8 Output Power Continuous Average Power RMS, 1kHz, 1.0% THD+N @ 2Ω 2x 2200 W @ 4Ω 2x 1400 W @ 8Ω 2x 760 W Bridge @ 4Ω 4400 W Bridg…

3, 0 Safety Precautions 1 General Information 1.1 Introduction 1.2 Main Characteristics 2 Controls: Where and What? 2.1 Front Panel 2.2 Rear Panel 3 Installation and Operation 3.1 Connections 3.1.1 Dual Mode (Stereo) 3.1.2 Parallel Mode 3.1.3 Bridge Mode (Mono) 3.2 Troubleshooting 4 Technical Spe…

10, In the event of incorrect connection or misfunctioning, the amp will activate one or more of its LED to warn about the problem. Correct function. CLIP: Clipping situation on the output. No Signal: No Input Signal is reaching the amp. Overheating: The amplifier has rea- ched the maximum operati…