AquaCraft Top Speed 2 HCAB5010 Assembly And Operation Manual

16, Gently pull the rubber drain plug located on the transom and allow any water that may have found a way inside the hull to drain out. Be sure to replace the plug before running the boat again. MOTOR MOUNT SCREWS Moisture inside the hull can cause the 6-32 cap head screws that hold …

7, ❏ 7. Remove the template and use a 3/16" [5mm] (or 13/64") drill bit to increase the size of the hole to install the 6-32 brass thread inserts into the transom. Using 5-minute epoxy, coat the inside of the hole and outer threads of the 6- 32 inserts before screwing them in. This wi…

1, AquaCraft Top Speed 2 HCAB5010 ASSEMBLY AND OPERATION MANUAL Warranty AquaCraft™ will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft will either repair or replace, at no charge, the incorrectly made part. Make sure you save the receipt or invoice you were g…

11, ❏ 3. Make sure the engine is neutral (use the stand to hold the engine straight) and use a felt-tip pen to make a mark where the pushrods meet the holes in the steering servo arms. Remove the pushrods now so that you can easily work with them in the next step. ❏ 4. Use pliers t…

12, secure it by tightening the socket head screw (3/32" [2.5mm]) as shown. Cut off the excess after making sure that there is enough throttle cable to allow the engine to move freely. Hint: You can use silver solder (GPMR8070) and coat the ends of the cable to keep them from fraying. ❏ 1. The f…