Rane TTM 57SL Operation & User’s Manual

14, Manual-12 Setting up your turntables 1. Set the tone arms to the specific recommendations of the cartridge used, such that the needle never leaves the record, but not heavy enough that it heats up significantly. Both produce poor tracking. 2. If the track plays backwards, try swapping…

40, Manual-38 Good Signal Clean signal with 100% tracking. No Signal TTM 57SL is not receiving any control signal — check your connections as shown on page Manual-3. CD Player into Phono Input TTM 57SL is set to receive phono level input. Set to the correct value on the setup page. Phono into L…

34, Manual-32 (Group B3) playback To access this group, press the GROUP button on the mixer, then press B3. is group contains all the software functions required for mixing in int mode. To select which of the Virtual Decks a given effect is applied to, press the mixer’s DECK but…

30, Manual-28 Vinyl Control Track start offset If you find that you have cue burn at the beginning of the re- cord, you will notice that the tracking will be poor at this point. Use the two knobs to offset the start point, so that the track will start playing from a point further int…

27, Manual-25 Recording Scratch LIVE allows you to record one of six stereo signals from the TTM 57SL: • Main Mix • AUX BUS (sum of MIC, AUX and Flex-FX Return) • PGM 1 (a) Pre-Fader • PGM 1 (a) Post -Fader • PGM 2 (b) Pre-Fader • PGM 2 (b) Post -Fader Stereo recording is…

10, Rane TTM 57SL Manual-8 Serato and Effects Control Panel ese “soft” controls have multiple functions for controlling Serato Scratch LIVE software. ese also control the Internal Digital Effects when the mixer is operated stand-alone without a computer. Scratch LIVE controls are described on pag…