Lincat Opus 700 User And Installation Instructions Manual

10, IS318 ECN3011 10 SECTION 9 - ACCESSORIES ACCESSORY INSTALLATION INSTRUCTIONS 6.1 OA7907 Floor Stand • Position Salamander on top of floor stand, lining up the mounting holes in the frame with the pierce nuts in the base of the unit. • Fix in position using fo…

11, IS318 ECN3011 11 SECTION 10 - SERVICE INFORMATION Catering equipment should be routinely serviced to ensure a long and trouble free life. It is recommended that a competent qualified engineer service this appliance every 6 months. For help regarding the installation, maintenance …

9, IS318 ECN3011 9 SECTION 8 – WIRING DIAGRAM E278 1 4 5 7 6 9 8 10 12 13 NE39 GREEN NEON EN10 ENERGY REGULATOR RE28 RELAY TE45 TERMINAL BOX 3 11 EL223 2750W ELEMENT (2 off) 2 ENSURE L1, L2 & L3 ARE LINKED ON TE45. THIS APPLIANCE IS SINGLE PHASE. …

7, IS318 ECN3011 7 SECTION 5 – COMPONENT REPLACEMENT HOOD 1. Remove the 2 screws on the underside of the front of the hood, at either side of the cooking cavity. 2. Release the 2 tabs by pulling them into the cavity. 3. Hinge back the hood to clear the inner flue and s…

6, Lincat Opus 700 IS318 ECN3011 6 Branding Plate Grill Shelf Shelf-mounted Drip Tray Figure 3 GRILL PAN An enamelled drip tray, or grill pan, is provided and sits in the base of the cooking cavity. This should always be in place when the grill is in use. CLEANING Ens…

5, IS318 ECN3011 5 ELECTRICAL SUPPLY AND CONNECTION Connection of the electrical supply cable is made at the rear of the unit. Unclip the protective cover and fit a suitable cable into the strain relief and then to the inlet terminal block. The unit is supplied for connect…