Lobo Drives LX80 Operation & User’s Manual

22, 6-6 1 +12 volts 24 not used 2 TxD (transmit data) 23 DB-25S pin 9 3 TxC (transmit clock) 22 DB-25S pin 24 4 RTS (request to send) 21 DB-25S pin 4 5 DTR (data terminal ready) 20 DB-25S pin 20 6 RxD (receive data) 19 DB-25S pin 3 7 RxC (receive clock) 18 DB-25S pin 17 8 CTS (clear to send) 17 DB-25S p…

3, ii TABLE OF CONTENTS SECTION DESCRIPTION PAGE SECTION I 1-1 1.1 Introduction 1-1 1.2 System Description 1-1 SECTION II - UNPACKING THE INTERFACE 2-1 2.1 Visual Inspection 2-1 2.2 Unpacking the Expansion Interface 2-1 2.3 Unpacking Disk Drives 2-2 SECTION III - SETTING UP THE SYSTEM 3-1 SECTION I…

8, 3-1 SECTION III SETTING UP THE SYSTEM Find a space large enough to hold all the components of your system, plus adequate work space. Be sure you will have enough AC power outlets to run all the components of your system. LOBO DRIVES recommends the use of a fused, switched power distribution box. To…

24, Lobo Drives LX80 6-8 c. If you are modifying for 117VAC, use, refer to Figure 6-1b: i. Connect the cold (white wire) side of the AC input power to the bottom lug of the ON/OFF switch. This restores the neon lamp operation. ii. Rewire the power supply transformer so that power comes in on pins 1 & …

10, 3-3 Figure 3-2. Mini and 8" Floppy Disk Connections NOTE Check the drive part numbers. Only one drive can contain termination resistors, and that drive must be the furthest from the interface, Any unused connectors must be at the END of the cable. 9. If you are installing standard …