VEXILAR LC-10 Operation Manual

8, Drill out the hole, install one screw, and tighten the bracket down securely. Be sure to seal any holes drilled into the transom with silicone to prevent water from leaking into the boat. If you have trouble keeping a clear reading, try tilting the transducer in the bracket so that th…

6, VEXILAR LC-10 Now locate the transducer and the remaining hardware. Install the transducer onto the angle bracket. The flat edge of the transducer should be facing the boat. Install the two short screws through the transducer slots and into the angle bracket slots. Place the washers and then the nuts onto the sc…

11, RANGE CONTROL The two buttons at the top right of the control panel set the depth range when the Auto Mode is off. Pressing the SHALLOW button changes the range to the next shallow- est range. Pressing the DEEP button changes the range to the next deeper range. LIGHT ON/OFF Press the LIGHT…

16, SEEING FISH With the FISH ID feature on, any target that the LC-10 identifies as a fish will change to a fish symbol shortly after it appears on the screen. With the FISH ID feature off, the Clean Line feature will help you identify fish from floating debris. If the target appears cleaned ou…

18, ICE FISHING The stable platform of ice lets you concentrate on your bait and the fish around it. The bottom becomes less impor- tant because it never changes. The only movement on the display is of your bait and fish. Unlike open water use, the direction in which the trans- ducer is…