Thermal Solutions SOLARIS Service Instructions Manual

56, Thermal Solutions SOLARIS 56 Display Factory Setting Range/Choices Description Opera- tional SP 180°F 60°F to 230°F Operational SP Setpoint used in Local Setpoint Mode when not servicing a Domestic Hot Water Priority (DHWP) request. On Point -5°F 0°F to -99°F On Point The water heater starts when the water temp…

23, 23 Figure 12: Water Piping (Single Water heater) Table 2 - Solaris Water heater Flow and Pressure Drop Water Heater Model 20° ΔT (max) 40° ΔT (min) Supply/Return Pipe (in. dia.)Δ P (ft) Flow (GPM) Δ P (ft) Flow (GPM) SOL-500 6.9 41 1.4 20 2 …

68, 68 Thermal Solutions (seller) LIMITED WARRANTY LIMITED WARRANTY Subject to the terms and conditions herein and except as pro- vided below with respect to products or parts not manufactured by Thermal Solutions, Seller warrants to the original owner at the original installation site that product…

48, 48 X. Thermal Solutions Water heater Control TM (TSBC TM ) A. INTRODUCTION - The intent of this section is to briey summarize the controllers capabilities, familiarize the user with its basic features and to list the factory supplied default settings. Read the additionally supplie…

22, 22 escape of air trapped in the water heater. To perform a long term pressure test including the water heater, ALL trapped air must rst be removed from the water heater. A loss of pressure during such a test, with no visible water leakage, is an indication that the water heater …

53, 53 Display Factory Settings Range/Choices Description Local PID I 30 0 to 10000 Local PID I Integral Gain value for water heater outlet temperature sensor control Modes. A smaller value makes the Integral ramp in less time (i.e.., faster). Integral is a secondary PID modulation rate tuni…