OWC Mercury Rack Pro mini-SAS User Manual & Owners Manual

18, OWC Mercury Rack Pro mini-SAS Chapter 3 - Formatting ➇ If you like, you can specify the drive letter designation for your new drive. Otherwise, one will automatically be assigned. Click “Next.” ➈ Before you can use the drive, it must be format- ted. On most systems runnin…

10, 2.3 Connections to Computer 1. Plug the power cable into the wall and into the OWC Mercury Rack Pro. 2. Verify the voltage switch is set properly for the country you reside in. 3. Connect the mini-SAS port to your controller card. If sold as a precongured solution, your OWC Mercu…

9, OWC Mercury Rack Pro mini-SAS Chapter 2 - System Setup 2.2 Replacing Drives If one of the drives fail, the corresponding activity LED will light up solid red If only one drive is defec- tive and your controller card’s RAID mode is set to RAID 1, RAID 3, RAID 5, or RAID 10, the d…

6, OWC Mercury Rack Pro SAS Chapter 1 - Introduction 1.6 RAID Modes The OWC Mercury Rack Pro mini-SAS does not have any RAID functions built in; however most RAID cards you will choose to use with the OWC Mercury Rack Pro mini-SAS will. These denitions of dierent RAID modes are provid…

3, OWC Mercury Rack Pro mini-SAS OWC Mercury Rack Pro mini-SAS Table of Contents 1 INTRODUCTION 1.1 SYSTEM REQUIREMENTS 1.1.1 Mac Requirements 1.1.2 PC Requirements 1.1.3 Supported Hard Drives 1.2 PACKAGE CONTENTS 1.3 ABOUT THIS MANUAL 1.4 REAR VIEW & CABLE CONNECTIONS 1.5 FRONT VIEW & LED INDICATORS 1.…

5, OWC Mercury Rack Pro mini-SAS Chapter 1 - Introduction 1.5.1 LED Indicators Power Input Voltage Switch External mini-SAS Port Cable Connections: 1. Plug the power cable into the wall and into the OWC Mercury Rack Pro. 2. Verify that the voltage switch is set properly for your country. 3. Connect y…