Crest Electronics CDVS-5400 SERIES Operation & User’s Manual

54, -54- CDVS-5400 SERIES DVR 11. Troubleshooting If you run into any problem using this system, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact nearest service facility. Symptom …

34, -34- CDVS-5400 SERIES DVR 5.13 Sensor & Output a) b) c) a) Set Sensor -Use : check external sensor 1 ~ 16. - Type : Set type of sensor. To change type just click each buttons. - ‘NO(Normal Open)’ type on usual time. - 'NC(Normal Close)’ when control output. - Record :…

39, -39- CDVS-5400 SERIES DVR 6.1 Installation Center Program 1. Insert enclosed CD title in your PC.(CD-ROM drive must be installed) 2. When program starts, select ‘Software’ and then press ‘Center Software’. 3. Center program will be installed automatically. Click! Install Center progra…

38, Crest Electronics CDVS-5400 SERIES -38- CDVS-5400 SERIES DVR 6. Center Program(Remote Client program) Center Program is remote client program which enables to control site DVR where communication available. Fixed IP of site DVR is required. Without allowing connection at site DVR, no center user connection availab…

47, -47- CDVS-5400 SERIES DVR 8.3 Emergency Agent configuration at site Choose sensor (s) that related to current selected camera. Whenever the selected sensor (s) event happens, the camera start doing pre- defined actions (recording including intensive recording, pre-alarm, siren, a…