Thrane&Thrane SAILOR 500 FleetBroadband Installation Manual

81, 65 Chapter 6 6666 Service and repair Service and repair 6 6.1 Introduction The Thrane & Thrane SAILOR FleetBroadband systems are designed to operate without preventive routine maintenance. Although the system is designed and built very service friendly, we strongly recommen…

11, ix • Troubleshooting describes the function of the Reset button and the light indicators on the terminal. It also describes event messages that may appear in the web interface. This manual may not always reflect the latest software functionality of your transceiver. To obtain the l…

140, Thrane&Thrane SAILOR 500 FleetBroadband Appendix C: Grounding and RF protection 124 Separate ground cable C.9 Separate ground cable C.9.1 Ground cable - construction When dealing with electrical installations in a marine environment, all wiring must be done with double insulated, tinned, high quality and if exposed also UV resistan…

85, Chapter 6: Service and repair Replacing modules 69 6666 Service and repair Mounting the HPA module To mount the new HPA, repeat the above procedure in reverse: 1. Fit the threaded studs on the back of the HPA into the holes in the mounting bracket on the antenna. Apply a small amount of Loc…

93, Chapter 7: Troubleshooting Reset button 77 7777 Troubleshooting While the terminal is booting, press and hold the Reset button. For service use only! The bootloader initiates software upload. This firmware upload procedure is only supposed to be used if the other procedures fail due to …

67, Chapter 4: Hardware interfaces ISDN interface 51 4444 Hardware interfaces 4.6 ISDN interface 4.6.1 Overview The terminal has one ISDN connector for connecting an ISDN phone or an ISDN modem. The ISDN interface supports 56/64 kbps data rate. It is configured as the network side, i.e. Rx is …