Octagon 5445 Operation & User’s Manual

15, Flat Panel Display Flat panel displays use either 3V or 5V power. A jumper on the card sets the voltage interface level to match the panel voltage level. Also, some flat panels require a bias voltage. The 5445/5445E bias voltage is adjustable from +19V to +30VDC. The bias voltag…

17, Octagon 5445 Table 2–2 W1 – BIOS enable/disable jumper Pins Jumpered Description [1-2]* Enables the video BIOS [2-3] Disables the video BIOS * default 3. Start PC SmartLINK. Note Disable any shadowing in the Octagon CPU card SETUP program. 4. Power on the Micro PC system. The Octagon …

5, The most common failures on CPU cards are over voltage of the power supply, static discharge, and damage to the serial and parallel ports. On expansion cards, the most common failures are static discharge, over voltage of inputs, over current of outputs, and misuse of the CMOS …

6,  Failure on powerup: Even when there is not enough current to destroy an input described above, the chip may be destroyed when the power to the card is applied. This is due to the fact that the input current biases the IC so that it acts as a forward biased diode on powerup. This type …

18, Do you want to continue? (Y/[N]) Programming...Please wait.................. Verifying...Please wait.................... PGMVIDEO completed. 9. Power off the 5445/5445E and install your monitor/display. ≡ Ethernet Refer to Figure 2–1 for the location of various connectors. The 5445E …

16, J1 connector using a 50–position IDC connector with custom wiring. The Octagon Accessories and Expansion CD contains wiring diagrams for some of the displays. Table A–10 shows the pinout for connector J1. 4. Make sure the BIOS jumper is enabled — W1[1–2]. 5. Configure a…