REMEHA Quinta 85 Manual, Technical Information

49, 49 8.9 Safety interlock As standard the boiler is supplied with an interlock carrying a 24 Volt boiler control circuit. To use first remove the fitted wire link (on RH side of terminal block between 10 and 14). Any external devices required to stop the boiler should then be wired in seri…

59, REMEHA Quinta 85 59 11 INSPECTION AND SERVICING INSTRUCTIONS 11.1 General The Remeha Quinta 85 has been designed to need minimum maintenance, but to ensure optimum efficiency we advise that once a year the boiler should be checked and if necessary cleaned and reset. All service and maintenance must …

46, Remeha Quinta 85 46 Fig. 16 Fitting the interface 05.W4H.79.00008 8.4.2 Analog control (0 -10 Volt dc) The heat output modulates between the minimum and the maximum value on the basis of the voltage supplied by an external analog (0 -10V, volt free) input (terminal connections 1 (gnd)…

62, Remeha Quinta 85 62 11.9 Cleaning/replacing the ignition/ionisation electrode Remove the two retaining screws on the electrode assembly, remove assembly and examine for wear and dirt, clean and re-gap electrode (3mm) if in good condition. Replace electrode assembly if necessary -…

5, 5 PREFACE These technical instructions contain useful and important information for the correct operation and maintenance of the Remeha HTG boiler, model Quinta 85. Read these instructions carefully before putting the boiler into operation, familiarise yourself with it’s control …

55, 55 6 Only with rematic ® SR 5240 C1 or 2945 C3 K control: Check the communication between control and boiler by means of the two LED’s on the interface, visible through the transparant part of the control panel. 00.W4H.79.00019 LED 1 is not flashing? Interface or contr…