Lux Products P711 Installation And Operation Instructions Manual

16, B/O CIRCUIT BOARD OPTION (FOR HEAT PUMP APPLICATIONS): This setting is a plastic shorting cap (called a jumper) which determines the operation of the shared B/O wire terminal connection. This jumper must remain installed for a Heat Pump system to be able to provide heating and cooling as neede…

24, Lux Products P711 KEYPAD LOCKOUT: You can lock the front panel buttons to prevent unauthorized tampering of your thermostat settings. TO LOCK THE KEYPAD: Start with the thermostat at rest, and the display backlight NOT illuminated. Press the NEXT button one time to illuminate the display screen, then press…

10, 2 / 3 / 4 WIRES CONVENTIONAL, NON HEAT PUMP 1-STAGE, HEAT ONLY (INCLUDING MILLIVOLT) NOTE: THE BLACK TERMINAL LETTERS ARE TYPICAL, GRAY TERMINAL LETTERS ARE BRAND SPECIFIC W1 4W X F G RH VR Factory RH-RC Jumper Wire Installed #1 C FAN 24V HEAT TRANSFORMER OPTIONAL SYSTEM COMMON HEATER 10 …

7, CONNECTING THE WIRES: When attaching the wires to the thermostat, please ensure that the bare wire ends are held ALL the way into the terminal block while the screw is being tightened. WIRING BASE PLATE NOTICE: This thermostat model is part of a family of similar models that have the same…

15, INSTALL BATTERIES INTO THERMOSTAT: Install two brand new Energizer ® or DURACELL ® “AA” size alkaline (only) batteries, into the thermostat’s battery compartment. Ensure the batteries are installed in the proper direction. GAS / ELEC CIRCUIT BOARD OPTION (“G” TERMINAL FAN OP…