Response SA1 E Installation And Operating Instructions Manual

6, Response SA1 E Remote Control Unit The Remote Control Unit is used to Arm and Disarm the system . The Remote will activate the Instant-Arm, Delay-Arm or Disarm functions. The Remote Control also incorporates a Personal Attack Switch (PAS). Activating the PAS will immediately initiate a …

20, Disarming the System The system can be disarmed using either the Remote Control or the Remote Keypad as follows: Remote Control: P ress the button. T he Siren will acknowledge the Disarm signal by b eeping twice unless beep disable has been set. Remote Keypad: Press…

1, SA1 E, SA1 E PLUS, SA1PF E and SA2 E Alarm Systems Installation and Operating Instructions 0 1 2 3 4 5 6 7 8 9 2 1 …

4, System Arming The system has an Instant-Arm and Delay-Arm mode. If the system is armed in Instant-Arm mode then all detectors will immediately become fully armed. Any detector triggered while the system is armed will immediately sound an alarm. Entry/Exit Delay If the system is…

25, 25 P IR Movement Detector not detecting a person’s movement 1. Ensure the battery clip is securely connected. 2. Ensure the ‘House Code’ is correctly set to the same code as all other system devices. 3. Sensitivity set too LOW - reset to HIGH sensitivity, (i.e. DIP 5 of SW3 ON). …

18, Testing an Installed System The system should be tested at regular intervals (at least every 3 months) to ensure that it is operating correctly. 1. Before commencing testing please ensure the following: − The Siren is in Operating Mode and Disarmed − There is no movement or peopl…