JOVY Systems iSolder-40 Operation & User’s Manual

6, 6 Initial set-up Packing list: Item Code Quantity Solder Station JV-SSS 1 Main tip JV-ST1 1 Hand piece holder JV-SS2 1 Cleaning sponge JV-SS3 1 Protective Pad JV-SS6 1 Power cord JV-SS7 1 JV - ST1 JV - SS6 JV - SSS JV - SS2 …

8, JOVY Systems iSolder-40 8 4- Plug the power cord into electricity supply and switch on the iSolder-40. 5- If the tip is inserted correctly a green led indicator will start flashing – Heating up mode. If the tip inserted wrongly the led color will be red. 6- Wait for the led indictor light to become green and sta…

13, 13 Hints and Tricks  Tip oxidation removal: Firstly, clean the tip using a wet sponge then clean with wire brush. Secondly, use a tip re-activator chemical to remove hard residues and oxidation, and finally re- tinning using solder wire (flux cored).  Make sure that the tip type is compati…

11, 11 Tip care and selection Available tips for iSolder-40: JV - TP1 JV - TP2 JV - TP3 JV - TP4 JV - TP5 JV - TP6 …

12, 12 Guide for tip selection: Good Too light Too heavy The ideal tip choice is the tip which its active area should cover completely the solder area. The best percentage of soldering area to tip active area is 2:1. Tip care guide for longer life time: - Clean the tip by wiping it …

10, 10 3) Sleep mode When the iSolder-40 controller senses no usage for 5 minutes, the iSolder-40 starts the sleep mode for saving power. The indicator of this mode is a flashing red led (short on; short off). To get out from sleep mode and turn to operating mode, move the hand…