Vinyl Express Qe60 Operation & User’s Manual

65, 4 – 23 Use the , , , and (POSITION) keys to move the cutter pen to alignment point 2 (any point on the X-axis for the previously plotted medium). The coordinates displayed here indicate the distance from alignment point 1. Press the (ENTER) key to calculate the X-axis angle of inc…

111, A – 5 Appendix D Menu Tree COND. PAT. DUMP PRESS TEST CUT MARK MODE MARK POSITION MARK TYPE MARK SIZE MARK DIST. ADJ. MARK OFFSET MARK SENSOR ADJ1 MARK SENSOR ADJ2 MARK AUTO SCAN MARK SENSOR ADJ SET BLADE GROUP FACTOR CLEAR GROUP STEP SIZE ORIGIN PT COMMAND GP-GL COMMAND HP-GL…

50, 4 – 8 4.6 Auto-Registration-Mark-Reading Settings (Option) These settings enable pre-plotted media to be cut without any offset by reading the registration marks using the cutting-plotter sensor and adjusting the axes to suit the coordinate data. The following precautions must b…

102, Vinyl Express Qe60 6 – 2 6.1 The Cutting Plotter Does Not Operate When Turned On 6.2 The Cutting Plotter Does Not Operate Correctly Symptom Cause Solution The STATUS lamp on the control panel does not light up. Power is not being fed to the cutting plotter. Check to confirm that the power cord is securely co…

21, 2 – 7 Pressing the or key displays “ROLL1 PRESS ENTR”, “ROLL2 PRESS ENTR”, and “SHEET PRESS ENTR”. Select “ROLL2 PRESS ENTR” or “ROLL1 PRESS ENTR” and then press the (ENTER) key to confirm. When “ROLL2 PRESS ENTR” is selected, only the medium width is detec…

66, 4 – 24 4.9 Distance Adjustment This function corrects any deviation in the length of cut or the plotted line segments, which occurs depend- ing on the medium being used. The adjustment value for the deviation is specified as a percentage of the total distance. For example, a setting o…