Sanav GC-101 Operation & User’s Manual

3, 3 1. Hardware Description 1.1 Front Face 1.2 Side Face GSM Status Indicator Flashing: Searching GSM signals Light on: GSM fixed SOS Button Press when in an emergency GPS Status Indicator Flashing: Firmware running Light off: Searching GPS signals Light on: GPS fixe…

33, 28 5.16 Input TCP/IP Address This function is to input TCP/IP address for TCP transmission. Please note that data will only be uploaded to this TCP/IP address when TCP transmission mode is selected. The SMS command is as following: Setup format：#「username」,「Password」,「…

4, 4 Below is the indication of LED light status of GC-101 When you operate the GC-101, there are 4 different color lights to indicate different status of GC-101. Please refer to below chart for the detail information. …

13, Sanav GC-101 8 5. Setup GC-101 currently provides the SMS commands for setup. You can setup the GC-101 by following the instructions shown in this chapter via SMS from a cellular phone. Key the specific SMS message in your cellular phone as the instruction and send it to the SIM number of GC…

19, 14 5.6 Set up Auto Report Use this command to set up the frequency of Auto Report. If you send the SMS according to the example shown below to GC-101, you will have an Auto Report Message every 300 seconds for 99 messages. Once the loop is done, you can send a SMS message to u…

23, 18 The table 5.9.2 shows each confirmation message reply after setup. Table 5.9.2 Situation Message Reply [username] + Device is switching to HTTP/SMS mode [username] + Device is switching to HTTP mode [username] + Device is switching to SMS mode [username] + Device…