XM Controls Tandem-Wire Operation Manual

15, 6. Select the corresponding top left or top right Soft Button on the XM Controller. 7. Move the wire to the other corner and check the Meta Tracking Laser Display to ensure the image displays a mirror image. 8. Position the torch at a starting point. 5.2.3 Tracking Laser Calibrat…

22, 6.2.6 Joystick Controls The Joystick Controls are programmable (see section 4.8.3.3). Each Joystick is divided into two axis of motion: a white axis and a yellow axis with corresponding labels. Each axis has programmable parameters (Command / High Speed / Low Speed). Joystick Y…

23, XM Controls Tandem-Wire 6.3 Mode Of Operation Select 6.3.1 Weld Mode To access WELD Mode, press the WELD Mode button represented by the icon above. The Weld screen is divided into three main sections. The top section contains the Soft Button labels. The center section contains weld sched…

26, 6.3.1.7 System Messages System Messages - Displays each occurrence and the time they took place. 6.3.1.8 Meters Meters - Displays four (4) parameter meters at one time. Each meter can display the following: • Module name • Parameter Name • Real time va…

33, 9.2 Components of the main display Sensor Image: This is the profile of the surface seen by the scanning spot sensor. The sensor can only see light of the same wavelength as the projected laser and cannot see any background illumination. In this way only the surface profile o…

1, Revision 0 May 2007 Tandem-Wire SAW System Operation Manual Advanced Manufacturing Engineering Technologies X M Controls …