Z Rapid SL series Operation & User’s Manual

8, - 6 - The recoater sweeps the resin during printing. Figure 5.The Build Chamber The resin vat (see Figure 6) is located below the build plate and contains resin. Figure 6.The Resin Vat Note: Open the vat access door, to locate the tap for draining out resin. Build …

10, - 8 - for resin which does not require heating, shut off the heater system. 2.1.4 Monitor The monitor on the SL series 3D printer has a touch screen feature. 2.1.5 Buttons & Alarm/Speaker Figure 9.Buttons &Alarm/Speaker a) USB Slot – Insert USB to copy SLC files to compu…

29, - 27 - 6 Contact Us Z Rapid Technologies Co., Ltd Tel: 0512-63398240/63398241 0512-63398242/63398243 Website: www.zero-tek.com (Leave a message on our website) Fax: 0512-63398290 Email: [email protected] Address：No.13, Tongan Road West, Suzhou, Jiangsu Province, P.R.C …

20, - 18 - indicator bar will turn red. Top up the resin till the indicator bar turns blue (see details in Figure 20). Note: a) For Z/R Axis, this button controls the build plate/resin plunger upwards. In the Coating Axis, the button moves the recoate…

32, Z Rapid SL series - 30 - When no laser is detected or you encounter some other problems with the laser, you should do the self-test then contact and provide the error code to Z Rapid technical support for assistance. The system will start the self-test when the “LASER” key is switched to t…

2, Content 1 Introduction ............................................................................................................................... - 1 - 1.1 What is Stereolithography (SL)? ...................................................................................... - 1 - 1.2 …