VoiceAlert WirelessAlert System 6 VA6000S Operating Instructions Manual

6, VoiceAlert WirelessAlert System 6 VA6000S VoiceAlert User Manual and Sensors should you wish to add additional Sensor/s to a Zone in the future. Make sure that the trigger LED indicator Switch 1 (SW1) (Figure 4) is set to the on position. Make sure that the Optic PIR is set to on position (SW2) (Figure 4). Optic is …

10, VoiceAlert User Manual 2.5.5 Installation for Reducing False Triggers Use the horizontal filter to create a more horizontal area of detection. For example, if you wish to exclude large plants of a certain height directly underneath the Sensor from triggering the Sensor when blowi…

8, VoiceAlert User Manual Figure 5: PIR Sensor mounted at standard height / no filter insert. 2.5.2 Installation for Increased Detection Distance If you want to increase the distance of detection to slightly more than 12 m, secure the Sensor low down (app. 1m above ground) and tilt the Sensor to …

11, VoiceAlert User Manual 2.6.2 Setting the trigger indicator LED Once you have finished programming / installing the Sensors, it is recommended that the trigger indicator LED be turned off using switch SW1 (Figure 4). This will also extend Sensor ba…

15, VoiceAlert User Manual 8 Disclaimer It is the responsibility of all installers and users of WirelessAlert products to read and fully understand manuals supplied with the products, to comply with all warnings and to communicate these to relevant parties. It must be clearly understood t…