Zero88 Jester Operating Manual

28, Jester Operating Manual Auxiliary Control 28 of 50 Jester Manual 73-403-00 Issue 1.1 deactivating the auxiliary, however SHIFT must be held to control the auxiliaries themselves (unless they are locked-on, see below). Fader Control of Auxi…

25, Run Mode Jester Operating Manual Jester Manual 73-403-00 Issue 1.1 25 of 50 Moving between Chase Steps - Manual Stepping 1. First select the memory or submaster containing the chase you wish to step though. 2. Move the SPEED control to grab the currently programmed value, then move the…

26, Jester Operating Manual Run Mode 26 of 50 Jester Manual 73-403-00 Issue 1.1 Removing Sound Input If the external sound source is removed, the chase will advance at the rate set on the speed control. If the speed control is set to Manual, the cha…

41, Glossary Jester Operating Manual Jester Manual 73-403-00 Issue 1.1 41 of 50 Go A function of the PROGRAM/GO button. This triggers a fade between one cue and the next, over a pre-defined time. Grab - The ability to push a fader up or down to ‘grab’ the level of the chann…

19, Zero88 Jester Program Mode Jester Operating Manual Jester Manual 73-403-00 Issue 1.1 19 of 50 Copying a Scene Memory 1. Use the cursor buttons to select a programmed scene memory. 2. Press the COPY/PASTE button. The contents of the scene memory will be stored internally. The light in the …

11, Program Mode Jester Operating Manual Jester Manual 73-403-00 Issue 1.1 11 of 50 Program Mode Introduction Program Mode on the desk is used to select and create new memories or submasters and enter lighting data. Once a memory has been created it can be modified within Program Mode, a…