Sartorius CISL3 Operating Instructions Manual

76, 76 Example: Entering Geographical Data and Performing External Calibration Preparation (see also “Calibration and Adjustment” in the chapter entitled “Operation”) § Remove the cap that covers the menu access switch on the left-hand side of the back of the indicator § Move…

35, You can assign codes (such as product name, batch number, etc.) for identifi- cation of measured values on printouts. Features – Assign up to four ID codes. – Assign both a name and a value for each ID code. – The name is left-justified and the value is right-justified on the printout.…

74, 74 1.944 Enter the sensitivity of the load cell (in this example, 1.9440 mV/V). Soft key l Confirm the value entered. The highlight bar is automatically positioned on the field for “Sensitivity 2”. – If the weighing platform consists of multiple load cells and the mean value was n…

85, Sartorius CISL3 85 -------------------- When calibration/adjustment has been completed, the GMP-compliant printout shown 14.01.2003 13:50 here on the left is generated. If the adjustment procedure is canceled (only calibration is Typ CW3P1-6DC-LCE performed), the last two lines, “External calibration�…

67, 67 A/D Converter Configuration (Examples) Example 1: Configuring the A/D Converter with a Weighing Platform Connected Preparation (see also “Calibration and Adjustment” in the chapter entitled “Operating the Combics”) § Remove the cap that covers the menu access switch o…

29, 29 Device Parameters Acoustic Signal An acoustic signal (single beep) is emitted when you press a key. A double-beep indicates that the key is not currently active. The acoustic signal can be switched on and off under: Device: Operat.: Acoustic signal Keypad You can block keypad functions by…