Royce Union Cruiser bicycles Owner's Manual

3, 3 Owner’s Bicycle Identifi cation Record NOTE: This information is only available on the bicycle itself. It is not available from Royce Union. Each Royce Union bicycle has a Se- rial Number stamped into the frame. The Serial Number (1) can be found on the bottom of the crank housi…

14, 14 Seat Installation Attach Seat to Seat Post (fi g 09): (pre-assembled on some models) • Loosen nuts on Seat Clamp (A) and rotate Seat (14) into riding position. • Put the Seat Post (33) fully through the Seat Clamp. • Tighten the Seat Clamp so the Seat stays on the se…

9, 9 Front Fender Installation Use Screw Driver and Wrench: 1. Front fender attaching hardware has been pre-assembled onto the fork. Remove the Bolt (8) and Washer (9) and Nut (10) from the fork crown. 2. Remove lower mounting Bolts (7) and Washers (6) from the dropout before…

18, Royce Union Cruiser bicycles 18 Brake System These models are equipped with a rear ‘coaster’ brake that is operated by rotating the crank backwards (fi g 15). g 15 Chain Adjustment g 16 30 B A Adjustment (fi g 16): The chain must be at the correct tightness. If too tight, the bicycle will be dif- fi cult to p…

20, 20 Repair and Service WARNING: • Inspect the bicycle frequently. Failure to inspect the bicycle and to make repairs or adjustments, as necessary, can result in injury to the rider or to others. Make sure all parts are correctly assembled and adjusted as written in this ma…

15, 15 CAUTION: Operate the Quick Release Lever by hand only. Do not use a hammer or any other tool to tighten the quick release lever. You must use strong force to move the quick release lever to the “close” posi- tion. If you can easily move the lever to the “close” position, the clamping…