Sea Tel 3011W-91 Installation Manual

120, SINGLE LEVEL MFG BILL OF MATERIAL FIND QTY PART NO REV DESCRIPTION REFERENCE DESIGNATOR 54 1 EA 121281 A CABLE ASS'Y, SMA(F)-SMA(M), 3 IN. 55 2 EA 114972-4 N CABLE ASS'Y, SMA(M) - SMA(M), 30 IN 56 1 EA 111079-6 G1 CABLE ASS'Y, SMA(M)-N(M), 6 FT. 60 …

45, 3011W-91 Installation Manual Setup – Band Selection 7-2 7.4. Cross-Pol only Quad-Band LNB This is the default setting for the Series 09 antenna pedestals with Quad-Band SMW LNB. Use the Band1 when you want Cross-Pol Band1 output to be routed to below decks, Band 2 sele…

106, SINGLE LEVEL MFG BILL OF MATERIAL FIND QTY PART NO REV DESCRIPTION REFERENCE DESIGNATOR 1 1 EA 124265 G ENCLOSURE, 1U RACKMOUNT, DAC-2200 SER 2 1 EA 122300 F LID, DAC-2200 SERIES ENCLOSURE 5 1 EA 120385-2 B1 BRACKET, LID, ACU ASS'Y, 4-40 PEM 7 1 EA 122…

63, Sea Tel 3011W-91 3011W-91 Installation Manual Setup – Blockage & RF Radiation Hazard Zones 11-4 ZONE 2 is not needed. Enter AZ LIMIT 3 value of 0000 and AZ LIMIT 4 value of 0000. Set EL LIMIT 34 to 0000. ZONE 3 is not needed. Enter AZ LIMIT 5 value of 0000 and AZ LIMIT 6 value of 0000. Set EL LIM…

30, Installation 3011W-91 Installation Manual 3-11 3.7.5.4. RXIF to the Satellite Modem Connect J7 “RF OUT” on the rear panel of the ACU to the RX Input connector on the Satellite Modem. The RX signal level of the J7 output of the ACU is approximately unity with J6 input due to a…