Sea-doo SPORTSTER 4-TEC Shop Manual

14, LMR2003-001_002A.FM XI 1. Remove old gasket and other contaminants with Loctite Chisel remover (P/N 413 708 500). Use mechanical means if necessary. NOTE: Avoid grinding. 2. Clean both mating surfaces with solvent. 3. Spray Loctite Primer N on both mating surfaces and on both sides of gasket. Al…

13, X LMR2003-001_002A.FM Adjusting Screw 1. Apply here 2. Plunger 1. Adjust screw to proper setting. 2. Apply drops of proper strength Loctite thread- locker on screw/body contact surfaces. 3. Avoid touching metal with tip of flask. NOTE: If it is difficult to readjust, heat screw with a sold…

7, Sea-doo SPORTSTER 4-TEC IV LMR2003-001_002A.FM Subsection 04 (MAGNETO SYSTEM) 03-04-1 F01D4WS Loctite 243 Loctite 243 Loctite 243 Loctite 243 Loctite 243 Loctite 648 145 Nm (107 lbfft) Anti-seize lubricant Page heading indicates section and subsection detailed. Exploded view assits you in identifying parts and …

4, LMR2003-001_002A.FM I SECTION SUBSECTION PAGE SAFETY NOTICE.................................................................................................................................. II INTRODUCTION ...................................................................................…

10, LMR2003-001_002A.FM VII GENERAL INFORMATION In the marine industry, PORT, STARBOARD, BOW and STERN are used to refer to LEFT, RIGHT, FRONT and REAR respectively. They always refer to the operator’s position sitting in boat. TYPICAL 1. BOW (front) 2. STARBOARD (RH) 3. STERN (rear) 4. PORT (LH…