Seaboater 100 Manual, Specifiations

47, Jammers to be Spinlock and Organizers to be Custom Spinlock or Custom Yard: Qty Part No. Description 2 ZS1014C Main Halyard and Spare Main/Topping Lift Jammer 1 ZS1014C Masthead Spinnaker Halyard Jammer 2 ZS1014C Genoa & Fractional Spinnaker Halyard Jammers 1 ZS1014C Staysail Halyard 3…

34, System to operate off of the ship’s 24 volt DC battery system, with separate breakers on the main panel. There shall be a charcoal water filter in the system to filter all domestic water whether from tanks or shore hookup. Plumbing To be as called up in the General section and the Whale or Se…

51, Hard anodizing. 12.17. Painting Mast The mast will be faired and painted with AwlGrip or equal. 12.18. Windex Windex mounted on masthead. 12.19. Lights Provision is made to mount lights and manufacture protected guards where necessary, for the following lights: Masthead/Anchor Light Ste…

25, 7.5. Stern Tube Stern tube to be custom GRP fabrication, see detail drawing, no cutlass bearing required in sterntube. 7.6. Shaft Seal The stuffing box is to be a John Crane Manecraft “Deep Sea Seal”, type EM, water lubricated shaft seal, set number 7. 7.7. Shaft Strut Strut to be custo…

9, A four hour trial at maximum continuous power shall be run. Engine room cooling and combustion air supply system shall be checked at full power for satisfactory operation. All other systems shall be tried underway at sea. All sail handling gear and winches will be checked for proper…

18, Seaboater 100 Every effort is to be made to make sole panels as sound tight as practical. Floorboards to be lifted with suction cup handles (as used in the glass window trade). Attention must be paid to providing access to all portions of the bilge and all items of equipment. Specific panels will be des…