Utax DP 700 Service Manual

25, 3JX 1-3-5 U070 Adjusting the DP magnification Description Adjusts the DP original scanning speed. Purpose Make the adjustment if the magnification is incorrect in the main scanning direction or auxiliary scanning direction when the DP is used. Method 1. Press the start key. 2. Select the item …

49, 3JX 1-5-3 5. Remove two stop rings from the original feed belt shaft A and then remove the bushing, pulley, spring pin, original feed holder and original feed color A. 6. Remove the original feed belt shaft A from the original feed belt unit. 7. Remove the original feed belt shaft B from the …

35, 3JX 1-3-15 U411 When automatic adjustment has normally completed, [RESULT OK 00] is displayed. If a problem occurs during auto adjustment, [ERROR XX] (XX is replaced by an error code) is displayed and opera- tion stops. Should this happen, determine the details of the problem and either re…

53, 3JX 1-5-7 9. Remove two screws and then remove the reverse unit front cover. Figure 1-5-12 10. Remove the screw and then remove the CIS. 11. Replace the CIS. Install the CIS to the DP. 12. Refit the reverse unit front cover to the DP. 13. Connect the connector of the DP timing switch 2…

63, 3JX 2-3-3 YC1 33 OFM 0B O 0/3.3 V DC (pulse) OFM drive control signal Connected to the DP drive relay PWB 34 OFM 1A O 0/3.3 V DC (pulse) OFM drive control signal 35 OFM 0A O 0/3.3 V DC (pulse) OFM drive control signal 36 OFM B O 0/3.3 V DC (pulse) OFM drive control signal 37 OFM A O 0/3.…

45, Utax DP 700 3JX 1-4-5 C9050 DP lift motor going down error The pulse count lowered to 10000 at lift- ing down, however, the DP bottom limit switch could not be turned on. After one time retry, the DP bottom limit switch could not be turned on. Loose connection of the DP lift motor connector. Reinsert the …