Automatic Technology GDO-9V1 SecuraLift Installation Instructions Manual

17, SETTING LIMITS 17 STEP 16 SETTING TRAVEL LIMIT POSITIONS METHOD TWO: VIA THE TRANSMITTER IMPORTANT NOTE: The OPERATE button will not function until the open and close limits positions are set. Remove the controls cover to access the controls panel as shown in fig 26 page 16 16.1 CODING TRANSMITTER…

3, 3 SAFETY PRECAUTIONS Warning - It is vital for the safety of persons to follow all instructions. Failure to comply with the following Safety Rules may result in serious personal injury and/or property damage. Caution: If your garage has no pedestrian entrance door, an emergency access device s…

8, KIT CONTENTS ITEMS QTY one piece c-rail assembly 1 See fig 3 C-RAIL CH-1P VP1 ASSY P/N 01651 C-RAIL CH-1P VP1 ASSY P/N 01651 C-RAIL CH-KD 3P VP1 ASSY P/N 01650 ITEMS QTY GDO-9 SECTIONAL DOOR OPENER DRIVE UNIT---1 KEY RING TRANSMITTER PTX-4 PACK----------------1 (pack includes two keyrin…

6, 1) P.E. SHUNT 2) 24V POWER INPUT CONNECTOR 3) 10 AMP FUSE 4) SBY-3 BATTERY BACK UP CONNECTOR 5) MOTOR CONNECTOR 6) OPERATE (YELLOW) BUTTON 7) PLUS (+) (GREEN) BUTTON 8) PG-3 PROGRAMMER CONNECTOR 9) COURTESY LIGHT MODULE 10) FORCE MARGIN BUTTON 11) OPEN LIMIT LED 12) AUTO CLOSE TIME BUTTON…

20, CODING TRANSMITTERS 20 STEP 19 STORING TRANSMITTER(S) FROM A REMOTE LOCATION Using this method you don’t need to have access to the control panel on the Door Opener. However, you do need a transmitter that is pre coded to the controller’s receiver. IMPORTANT NOTE: The Door or Courte…

23, Automatic Technology GDO-9V1 SecuraLift FINAL SET UP 23 23. SETTING OF COURTESY LIGHT TIME The preset courtesy light time on the door opener is 3 minutes. This time can be changed by the following: 1. Press in and hold both the Auto Close Time button and Force Margin Set button (Fig. 43). 2. While holding in the two buttons, press the…