Qvis APOLLO PRO DC LX Operation & User’s Manual

10, Qvis APOLLO PRO DC LX 10 2.6.4 Audio signal output Commonly the output parameter of a DVR audio signal is greater than 200mv 1KΩ(BNC) which can connect a low impedance earphone and active sound box or other audio output equipments through a power amplier. If the sound box and the tone arm can …

54, 54 21). The storage time is not enough. Possible reasons are as followed: 1 Front monitor quality is bad. The lens is too dirty. The monitor is in back lighting installation. 2 The hard disk capability is not enough. 3 The hard disk is damaged. 22). The downloading les…

36, 36 (PPPoE setup) Picture 4.19 PPPOE Input the user name and password that the ISP (Internet service provider) provides. After saving it reboot your system. Then the DVR will build a network connection based on PPPoE. The IP address will change into a dynamic IP address after the above operation …

16, 16 3.5.2 Playback There are two methods for you to play the video les in the hard disk. 1). In the desktop shortcut menu. 2). Main menu>Record->Playback Note: The hard disk that saves the video les must be set as read-write or read- only state. (4.5.1) Picture 3.4 video p…

4, 4 4.4 System .............................................................................33 4.4.1 General ........................................................................33 4.4.2 Encode .........................................................................34 4.4.3 …

53, 53 15). Network connection is unstable. Possible reasons are as followed: 1 Network is not stable. 2 IP address is conicted. 3 MAC address is conicted. 4 The net card of the DVR is bad. 16). There is something wrong with the USB backup or writing a CD. …