HPI Racing Tonal Plexus TPX 2s Operation & User’s Manual

32, TPX2s/4s/6 Technical Specification Tuning Tables Tuning Protocol Tuning Resolution Physical Controls Polyphony Display Power 2048 notes per table, 1688 notes accessed by keyboard 32 User Programmable Tuning Tables (no protected registers) 32 x 2048 Notes = 65,536 pitches stored in nonv…

7, Side Panel Diagram MIDI IN Connect another MIDI controller to this jack, also used for uploading tuning tables to the keyboard. MIDI THRU This output sends MIDI data received at MIDI IN through unmodified to another MIDI device. MIDI OUT Connect a synthesizer, sampler or M…

3, Tuning Table Changes ....................................................................................................... 19 9. DIP Switches ............................................................................................................................ 20 Bank Select Fo…

13, Untuned Output Mode The Tonal Plexus keyboard normally sends tuned output corresponding to MIDI Note and Pitch Bend data stored in a Tuning Table; however, when the top panel TUNED OUTPUT switch is set to OFF, the raw MIDI Note and Channel data shown above is sent to MIDI OUT. This d…

31, Pitches are tuned incorrectly on a external MIDI synthesizer or sampler. YES • The patches you are using could be altering the Pitch Bending response. Try some other patches. • Check your synthesizer user manual; the synthesizer may have a fixed Pitch Bend range; . in which case your…

24, HPI Racing Tonal Plexus TPX 2s this mode, the center position of the MOD fader gives unmodified pitch, the top position bends pitch up a 12ET wholestep, and the bottom position bends the pitch down a 12ET wholestep. To engage this mode, turn the unit OFF and switch DIP switch 7 to the ON position, and then turn the unit back O…