PANASTEREO CX230EX Owner's Manual

2, PANASTEREO CX230 CINEMA MONITOR PANASTEREO CX230EX CINEMA BOOTH MONITOR OVERVIEW The CX230 Monitor is the world’s first computer controlled booth monitor. It is simple to use, provides advanced features not previously found in booth monitor equipment and has been designed for easy interface to…

10, PANASTEREO CX230 CINEMA MONITOR 17. Turn off both the Centre HF and LF amplifiers and turn on the Sub Bass amplifier. 18. Note the SPL reading on the RTA. 19. Select the “SOURCE” switch to “AMPS”, and select “SUB BASS”. 20. Adjust the “AMPLIFIERS - SW” trimpot so that the…

14, PANASTEREO CX230EX PANASTEREO CX230 CINEMA MONITOR MMIX Select Mix MAMP Select Amplifier Inputs MPRO Select Processor Inputs MMUT Select Mute Set Volume Commands: MVxx Set volume to xx, where xx is a number from “00” to “99”. …

4, PANASTEREO CX230 CINEMA MONITOR CX230 INSTALLATION CONNECTING THE SOUND PROCESSOR OUTPUTS. NOTE: For non-biamped installations, the left channel should be connected to the LL input , the centre channel to the CL input and right channel to the RL input. 1. SOUND PROCESSOR WITH U…

5, PANASTEREO CX230 CINEMA MONITOR CX230 INSTALLATION con’t CONNECTING THE MONITOR SPEAKER OUTPUTS Use medium gauge (minimum 0.75mm2) twin polarised wire (figure 8) between each of the monitor speaker outputs and the monitor speakers. The monitor speakers can be 8 or 4 ohms. If you are usi…