Pedal Valves PEDALWORKS PVI-21 Owner's Manual

1, Pedal Valves PEDALWORKS PVI-21 Owners Manual PEDALWORKS TM FAUCET CONTROLLER Model PVI-21 3 Year Limited Warranty Pedal Valve Inc. will repair or replace units with defects in materials or workmanship for a period of three years from date of purchase. Return unit to factory at the address below, freight pre-paid, and y…

2, Congratulations on your purchase of a PEDALWORKS tm Faucet Controller. It is a wonderful product that provides the cleanest, fastest, and most efficient way to operate any sink. It is designed to connect to and control any faucet, and built to provide you years of enjoyable service. Foll…

3, Contents Of Box Installation Tools Needed • Drill with 2” hole saw. A jigsaw or keyhole saw can be used instead, but the 2” hole saw is the easiest. • ¼” Drill bit • Crescent wrench •5/8” end wrench • 9/16” end wrench • ½” end wrench • 13/16” end wre…

4, 3. Using the template, mark the hole locations for the pedal arm, and the 4 mounting screw anchors. You have the freedom to mount the unit where ever you want. From our experience these are some guidelines we recommend: • If the cabinet has a divider between the left and right…

5, 6. Insert a plastic mounting screw anchor in each of the ¼” holes (4 total). 7. Lower PEDALWORKS tm through hole as shown, and install a mounting screw in each corner. 8. Re-insert pedal and phillips head screw. 9. Loosen bracket bolts so valve will slide up & down, and fron…

6, The flex lines should be hand tightened, and then turned gently with a wrench till you feel the rubber seals begin to firm up. About one full turn. Do not over tighten. 10. Connect the stainless steel braided lines as shown. Connects to Cold Supply Valve Connects to Cold Side of Faucet Make the c…