Turbo Garden TGP-SR-216 Operation & User’s Manual

9, 16. Check damaged parts: Check product to see if any parts are damaged. Damaged parts should be properly repaired or replaced by an authorized service center unless otherwise indicated else where in this instruction manual. 17. Always have your product repaired by an exp…

6, Turbo Garden TGP-SR-216 ·In case of skin or eye contact, follow the instructions below. Immediately rinse with water. Neutralize with a mild acid such as lemon juice or vinegar. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. If necessary, consult a physician. ·NOT…

4, TO REMOVE RECHARGEABLE BATTERY 1. Press the two Lock Clips Q firmly and pull the Battery Pack P out. See Fig. 6. …

2, TECHNICAL DATA (CORDLESS) Input Voltage For Charger 120 V ~ 60 Hz Battery Voltage 21.6V DC Cutting Width 25 cm Cutting Line Diameter 1.2 mm No Load Speed 10,000 rpm / min Normal Charging Time - New 3~5 hrs Machine Weight 3 kg Measured Sound Pressure Level 74 dB(…

8, 2. Consider your work area environment: Do not expose power tools to rain. Do not use power tools in damp or wet locations. Keep working area well lit. Do not use power tools in the presence of flammable liquids or gases. 3. Keep all children away from the product: Do no…

10, 5. Release the On/Off Trigger C to stop the machine. NOTE: The cutting elements will continue to rotate after the motor is switched off. REPLACING THE LINE SPOOL: NOTE: Be sure to remove the battery from the machine before you replace the line spool. 1. Press the Lugs…