Sig Marine DVP9000 Installation And Operating Manual

6, -5- Avoid low-points in vent pipe Clearance to surrounding surfaces Bending and installation of the vent pipe …

9, -8- Gas Supply and Connection The heater operates only on low pressure LPG gas (11"w/c / 0.5psi / 27.4 mB). If there is a propane fuel system installed a separate supply line must be supplied for the heater. This line must be equipped with a low-press…

12, -11- Troubleshooting WARNING: WHAT TO DO IF YOU SMELL GAS • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your vessel. • Leave the boat and ventilate with the appropriate equipment. • L…

7, -6- Installing the Flexible Pipe Four springs are installed between the inside and outside pipe to ensure that an even air space is provided. It is important that two springs be located at any bend in order to prevent the pipes from touching. …

10, Sig Marine DVP9000 -9- - The diagram is to illustrate a typical installation only and should not be used to illustrate any particular regulatory code, insurance requirement or to override manufacturer’s instructions on any fittings or components. - Install your propane system in accordance to lo…

8, -7- WARNING: Do not install the external flue cap within 20 inches (500mm) of a refueling fitting or fuel tank vent. …