Sig Marine P9000 Operating And Installation Instruction Manual

11, 11 5. Lighting Procedure 1) Open heater door 2) Turn GAS knob to LOW only as the high setting will not work when lighting. 3) Press knob and light burner manually (It may be necessary to keep clicking the lighter in order to keep the flame going to overcome th…

14, 14 Gas odor even when control knob is in OFF position 1. Gas leak. See Warning. Locate and correct all leaks 2. Check and, if required, replace the control valve. If operation is attempted with high pressure gas, the valve could fail. S…

9, Sig Marine P9000 9 some of these components vary by manufacturer. Install components as directed by manufacturer’s instructions. Existing System: Part# 19-151: Low Pressure Regulator Part# 19-100-10: 10ft Low Pressure Hose/ Part# 19-100-20: 20ft Hos…

7, 7 Deckfitting and Exhaust Cap Step - 1 Measure, cut or drill a 3" hole through the deck, ceiling or wall where the exhaust cap will be located. Step - 2 Make sure the sealing gasket is installed under the above deck-flange before screwing down the fitting. R…

15, 15 6. Warranty Policy We at Dickinson & Sig Marine wish to maintain a reasonable and easy system for returns, warranty, returns and exchanges. To accomplish this, we would like to inform you of some helpful guidelines and procedures to use and follow when s…

18, 18 7. Register your Warranty….. Please register your warranty with Sig Marine. Fill out and send back the warranty registration below. Make sure to include the serial # for our records. No warranty will be extended for improper installati…