SkyScan 87800 Instruction Manual

10, SkyScan 87800 10 POSITIONING THE ATOMIC CLOCK: There are two possible ways to mount the atomic clock: use of the foldout table stand, or wall mounting FOLDOUT TABLE STAND The foldout table stand leg is located on the backside. Pull the stand out from the bottom center edge of …

8, 8 OUTDOOR TEMPERATURE TRANSMITTER: The temperature is measured and transmitted to the atomic clock every 1 minute. The atomic clock will update the temperature display every 5 minutes. The range of the outdoor temperature transmitter may be affected by the temperature. …

12, 12 Problem: "--.-" appears in the outdoor temperature section of the LCD. Solution: 1) Remove the batteries of both units for ten minutes, then reinsert them again. Make sure the batteries are new and fresh. See setting up. 2) Move the atomic clock closer …

9, 9 WWVB RADIO CONTROLLED TIME The NIST radio station, WWVB, is located in Ft. Collins, Colorado and transmits the exact time signal continuously throughout the United States at 60 kHz. The signal can be received up to 2,000 miles away through the internal antenna in the at…

11, 11 MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) Remove the protective strip from one side of the tape. Adhere the ta…

3, 3 Weekday 5. After the clock receives the outdoor temperature the WWVB time code reception will automatically start. The clock will automatically set itself to the exact time, day and date after receipt of the WWVB time code reception. This typically takes over night. For be…