Smart Technologies 1710 Installation Manual

2, Smart Technologies 1710 FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is opera…

35, 99-00479-03 REV B0 Using the Interactive Whiteboard 29 Using the Interactive Whiteboard When your interactive whiteboard is installed, you need to: • configure SMART Board software • start SMART Board software • calibrate the cameras • orient the interactive screen This section …

16, 10 Installing Your Interactive Whiteboard 99-00479-03 REV B0 1. Place foam or a soft cloth onto a smooth, flat surface upon which you can rest the frame of the interactive whiteboard. 2. Carefully place the interactive whiteboard face down on the foam or soft cloth. Take care to…

15, 99-00479-03 REV B0 Installing Your Interactive Whiteboard 9 Installing Your Interactive Whiteboard In this section, you’ll: • attach mounting brackets to the interactive whiteboard (this page) • install the interactive whiteboard into the wall opening (page 12) • create a wall opening…

49, 99-00479-03 REV B0 Appendix A: Specification Drawings 43 2876 Views The figure below does not show the 1/2" (1.3 cm) gap between the casters and the floor. The levelling legs have a ± 1/2" (1.3 cm) range of adjustment. If you adjust these legs, make a corresponding ad…

37, 99-00479-03 REV B0 Using the Interactive Whiteboard 31 1. Close any open computer programs. 2. Shut down the computer. If you purchased a projector separately from your interactive whiteboard, put the projector into standby mode by following the manufacturer’s instructions suppl…