PUTHON 460HP Installation Manual

5, © 2002 Directed Electronics, Inc. 5 H1/2 WHITE (+/-) light flash output As shipped, the H1/2 WHITE wire should be connected to the (+) parking light wire. If the light flash polarity jumper is moved to the (-) position (see the Programming Jumper section of this installation guide)…

15, © 2002 Directed Electronics, Inc. 15 2. IIggnniittiioonn.. Turn the ignition on, then back off: (The H1/9 YELLOW wire must be connected.) 3. SSeelleecctt aa MMeennuu.. Press and HOLD the Valet/Program switch: (The Valet/Program switch must be plugged into the blue port.) After three…

2, Bitwriter™, Code Hopping™, DEI®, Doubleguard®, ESP™, FailSafe®, Ghost Switch™, Learn Routine™, Nite-Lite®, Nuisance Prevention® Circuitry, NPC®, Revenger®, Silent Mode™, Soft Chirp®, Stinger®, Valet®, Vehicle Recovery System®, VRS®, and Warn Away® are all Trad…

1, 460HP Installation Guide © 2002 Directed Electronics, Inc. Vista, CA N429P 4-02 NOTE: This product is intended for installation by a professional installer only! Any attempt to install this product by any person other than a trained professional may result in severe damage to a ve…

21, © 2002 Directed Electronics, Inc. 21 2-9 CHANNEL 3 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED/SECOND UNLOCK OUTPUT: Channel 3 can be programmed for these output configu- rations. The unit is set to the default validity output. To change the configuration, use the tw…

13, PUTHON 460HP © 2002 Directed Electronics, Inc. 13 Optional Sensor Harness, 4-pin Connector The four-pin sensor harness is optional, and is not included with this unit. RED (+) 12V Constant and BLACK (-) Ground These wires supply constant (+) 12 volts and ground to the optional sensor. BLUE/GREEN …