PSG CADDY ALTERNA Installation And Operating Instructions Manual

33, 33 3.3.1 THE SPEEDS Your furnace is equipped with a 4-speed blower. Using the pellet central processing unit (Pellet CPU), we have created 6 functional speeds. Refer to Table 2 below for the various speed configurations. Table 2 – The Speeds Speed Corresponding data CFM* STAT…

42, 42 4. MAINTENANCE 4.1 MAINTENANCE OF THE EXCHANGERS AND BLOWER HOUSING The heat exchangers are to be cleaned thoroughly at the end of each heating season. During the summer air is more humid with minimal natural flow in the furnace, in these conditions, remaining creosote and/or…

27, 27 RTD SUPPORT RTD SCREW ALREAD Y INSTALLED 2.10 TEMPERATURE PROBE CONNECTION (RTD) On the Caddy Alterna, a RTD has to be installed on the side of the appliance using the support provided with the unit. In order to secure the RTD support, remove the two screws already sec…

24, 24 2.8 INSTALLING THE PELLET CENTRAL PROCESSING UNIT (PELLET CPU) Different locations can be chosen to install the pellet central processing unit (Pellet CPU). First, choose the location to install the pellet central processing unit (Pellet CPU). It will be located on the left…

41, 41 3.6.2 EARLY SIGNS OF AN OVERFIRED FURNACE If you see a lazy, very high orange flame inside the firebox, it may be a signed thatyour furnace is overfired and getting too hot. Under normal conditions, the flame should be about 12 inches high and it should be lively. It should …

30, PSG CADDY ALTERNA 30 DAMPER DAMPER A/C COIL Recommended Installation with an AC unit Note : It is important to apply the sticker to the furnace and have the installer fill all fields. The last step consists of installing the coil handle supplied with the owner’s manual to the handle rod. …