Zenoah LRTZ2610 Owner's Manual

12, GB-12 SRTZ2610/SRTZ2610F/LRTZ2610 BLADES • When refilling the tank or resting, it is often a good idea to use the time to oil the cutting blades. • If a gap exists between the upper and lower blades, follow the procedure below to adjust them so that they fit more closely together. • …

1, GB-1 G B SRTZ2610/SRTZ2610F/LRTZ2610 SRTZ2610 SRTZ2610F LRTZ2610 G B OWNER’S MANUAL SHORT REACH TRIMMER LONG REACH TRIMMER 848A3393A0 (801) …

6, Zenoah LRTZ2610 GB-6 SRTZ2610/SRTZ2610F/LRTZ2610 WARNING Never place the throttle into the high-speed position when starting the engine. 3. After starting the engine, check to make sure that the cutting at- tachment stops moving when the throttle is moved fully back to its original position. If it conti…

14, GB-14 SRTZ2610/SRTZ2610F/LRTZ2610 9. Maintenance INTAKE AIR COOLING VENT WARNING •Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns. • When c…

8, GB-8 SRTZ2610/SRTZ2610F/LRTZ2610 MIN SPACING About 19 inches (48 cm) clamp arrow mark (1) 6. Set up MOUNTING ENGINE 1. Push the shaft tube toward the clutch housing and move it by hand to check that the drive shaft is engaged with the gears. 2. Insert the shaft tube into the clutch housing until i…

3, GB-3 G B SRTZ2610/SRTZ2610F/LRTZ2610 8 9 10 11 12 13 (SRTZ2610) (SRTZ2610F) (LRTZ2610) Information This machine is equipped with an Overload Cancellation Mechanism. When the cutting blades have got into metal wires or twigs difficult to cut, the mechanism works as a shock absorber, and…