Supermicro 7047A-T Operation & User’s Manual

29, Chapter 4: System Safety 4-3 4-3 ESD Precautions Electrostatic discharge (ESD) is generated by two objects with different electrical charges coming into contact with each other. An electrical discharge is created to neutralize this difference, which can damage electronic com ponents and pr…

103, Chapter 7: BIOS 7-29 7-7 Save & Exit This submenu allows the user to confi gure the Save and Exit settings for the system. Discard Changes and Exit Select this option to quit the BIOS Setup without making any permanent changes to the system confi guration, and reboot the computer. Sele…

71, Chapter 6: Advanced Chassis Setup 6-7 Figure 6-5. Mounting a SAS/SATA Drive in a Carrier ! Important! Use extreme caution when working around the SAS/SATA back- plane. Do not touch the backplane with any metal objects and make sure no ribbon cables touch the backplane or obstruct the airfl…

43, Chapter 5: Advanced Serverboard Setup 5-13 LRDIMM Memory Support Ranks Per DIMM & Data Width (Note 1) Memory Capacity Per DIMM (Note 2) Speed (MT/s) and Voltage Validated by Slot Per Channel (SPC) and DIMM Per Channel (DPC) (Notes 3, 4, 5, 6) 2 Slots Per Channel 1DPC/2DPC 1.…

19, Supermicro 7047A-T Chapter 2: Installation 2-5 Installing the Chassis Rails You will need to remove the top cover and the feet to add rack rails to the chassis. First, remove the top and right covers (top and left covers when standing as a tower chassis) by fi rst removing the screws that secure them to the cha…

38, 5-8 SuperWorkstation 7047A-73/7047A-T User's Manual Screw#1 Screw#2 Installing a CPU Heatsink 1. Do not apply any thermal grease to the heatsink or the CPU die; the required amount has already been applied. 2. Place the heatsink on top of the CPU so that the four mounting h…