Supermicro 5015M-NT Operation & User’s Manual

126, D-16 S UPERSERVER 5015M-UR/5015M-U/5015M-NTR/5015M-NT User's Manual Using the Disk Utilities The Disk Utilities enable you to format or verify the media of your Serial ATA hard disks. To access the disk utilities 1. From the Adaptec RAID Confi guration Utility Menu, select …

23, Chapter 2: Server Installation 2-7 Figure 2-4. Installing the Server into a Telco Rack Installing the Server into a Telco Rack To install the 5015M-UR/5015M-U/5015M-NTR/5015M-NT into a Telco type rack, use two L-shaped brackets on either side of the chassis (four total). First, d…

125, Appendix D: Adaptec HostRAID Setup Guidelines D-15 Deleting Arrays Warning: Back up the data on an array before you delete it to prevent data loss Deleted arrays cannot be restored. To delete an existing array: 1. From the main menu (shown on Page D-4), select Manage Arrays. 2. Select th…

49, Chapter 5: Advanced Serverboard Setup 5-15 Fan Headers The PDSMU has six fan headers, des- ignated Fan1 through Fan6. All are 4-pin fans to provide a Pulse Width Modulated (PWM) signal, however pins 1-3 of the headers are backward compatible with traditional 3-pin fans. Connect the C…

120, Supermicro 5015M-NT D-10 S UPERSERVER 5015M-UR/5015M-U/5015M-NTR/5015M-NT User's Manual Notes 1. Before adding a new drive to an array, be sure to back up any data stored on the new drive; otherwise, all data will be lost. 2. If you stop the Build or Clear process on a RAID 1, you can restart it by press- ing &…

124, D-14 S UPERSERVER 5015M-UR/5015M-U/5015M-NTR/5015M-NT User's Manual Rebuilding Arrays Notes: Rebuilding applies to Fault Tolerant arrays (RAID 1) only. If an array build process is interrupted or when one critical member is missing, you must perform a Rebuild to restore its functionality. Fo…