PowerStar SMX2000RMLV2U Operation Manual

5, 3Smart-UPS X-Series 2000/2200/3000 VA Operation Installation UPS For UPS installation information, see the Smart-UPS X 2000-3000 VA Quick-Start that is included with the UPS. The guide is also available on the enclosed CD and the APC Web site at www.apc.com. Network Management …

15, 13Smart-UPS X-Series 2000/2200/3000 VA Operation Emergency Power Off EPO Overview The Emergency Power Off (EPO) option is a safety feature that will immediately disconnect all connected equipment from utility power. The UPS will immediately shut down and will not switch to battery pow…

4, Smart-UPS X-Series 2000/2200/3000 VA Operation2 Rear panel Specifications Operating Conditions This unit is intended for indoor use only. Select a location sturdy enough to support the weight of the UPS and External Battery Packs (XLBP). Do not operate the unit where there is excessive dust, or t…

6, Smart-UPS X-Series 2000/2200/3000 VA Operation4 Operation Connect Equipment to the UPS Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not expect full battery runtime capability during this initial charge period. 1. Connect equipment to the ou…

10, PowerStar SMX2000RMLV2U Smart-UPS X-Series 2000/2200/3000 VA Operation8 Configuration UPS Settings Start-up Settings Use the display interface to configure these settings at initial start-up. The unit will prompt for a response to each setting, if not response is given, it will use the default setting. Note: The un…

14, Smart-UPS X-Series 2000/2200/3000 VA Operation12 Network Management Card Settings These settings are available only on units that have a Network Management Card (NMC). • NM C IP Address Mode • NMC Default Gateway Turn Off Delay 90 sec Set the value in seconds The amount of time that the …