STOKVIS ENERGY SYSTEMS ECONOFLAME R30 Manual, Installation Operation & Maintenance

26, 22 Doc653/30CV02A 6.3 Boiler module KM628 Lid closed Lid open 643 2 1 7 5 98 7 6 532 1 4 Fig.6 Boiler module 1 Operating mode 1 Parameter indication K Stand-by P1 Actual/required fl ow temperature q Automatic operation (winter position) P2 Actual/required hot water…

24, 20 Doc653/30CV02A 5.4.2 Water pressure 5.4.2.1 Operating pressure At a maximum fl ow temperature of 90°C and with the minimum water fl ow that occurs at a ∆t of 20K, the minimum operating pressure should be at least 1.5 bar. The operating pressure should be measured when the pump is swit…

28, 24 Doc653/30CV02A 2/3 Interlock circuit has been interrupted An external safety device connected to the terminals (ST 9.3-9.4) has been triggered. Check and repair this safety device. 4 No fl ame signal when the burner starts No fl ame is detected within the preset safety time when burner…

17, Doc653/30CV02A 13 - Adjustable response of the fl ow temperature to sensed room temperature - Calibration of the room sensor - Delay to fl ow temperature compensation due to external temperature up to a maximum of 3 hours - Holiday Programme - Frost protection system based on extern…

20, 16 Doc653/30CV02A Due to the high effi ciency, there may be condensate formation in the chimney even at high water temperatures. y The condensate drain should never be blocked! A direct connection to a brick chimney is not permissible, since the chimney losses must be less than 17%. The…

16, STOKVIS ENERGY SYSTEMS ECONOFLAME R30 12 Doc653/30CV02A Fig. 4 Connections of the R30 The appliance is suitable for a 230 V 50Hz power supply with live/neutral/earth. Other connect- ing arrangements are only permissible if an isolating transformer is used. The appliance is phase sensitive. The boiler can be switched on and off …