Star Micronics futurePRNT TSP100 Hardware Manual

16, – 13 – 3-4. Connecting the USB/PoweredUSB Cable to the PC 3-4-1. U Model Connect the USB interface cable to a USB port of your PC. 3-4-2. PU Model CAUTION Make sure that the PC is turned off before connecting the PoweredUSB cable (Y cable) or PoweredUSB cable (straight type). Connec…

10, – 7 – 3-1-2. PU Model CAUTION Make sure that the printer is turned off before connecting the PoweredUSB cable (Y cable) or PoweredUSB cable (straight type). (1) According to the cable used, install the connector cover onto the printer to prevent im- proper cable connections. …

9, Star Micronics futurePRNT TSP100 – 6 – 3. Setup 3-1. Connecting the USB/PoweredUSB Cable to the Printer 3-1-1. U Model Affix the ferrite core onto the USB interface cable and pass the cable through the cable sup- port as shown. Then, connect the USB interface cable to the printer. …

36, – 33 – 10-4. Electrical Characteristics 10-4-1. U Model (1) Input Voltage 100 to 240 V AC, 50/60 Hz (2) Current Consumption Operating: Approx. 40 W (at ASCII printing) Stand-by: Approx. 3 W 10-2. Auto Cutter Specifications (1) Cutting frequency Max. 20 cuts per minute (2) Thic…

27, – 24 – 2) Non-recoverable errors Error Description Head thermistor error Board thermistor error VM voltage error VCC voltage error EEPROM error USB error CPU error RAM error POWER Lamp Flashes at 0.5-second inter- vals Flashes at 2-second inter- vals Off Flashes at 1-second inter- val…

20, – 17 – Power switch 3-7. Turning Power On Make sure that the Power cord has been connected as described in 3-6. (1) Turn ON the power switch located on the front of the printer. The POWER lamp on the control panel will light up. CAUTION We recommend that you unplug the printer from the po…