Polypipe Under Floor Heating Systems Technical Installation Manual

16, Polypipe Under Floor Heating Systems Key design and installation information Material requirements (approx) Maximum heat output Approx. 100W/m 2 Recommended design ow temp 45° to 50°C Maximum circuit length 80m Maximum coverage per circuit 12m 2 Overlay™ oor panel Coverage 0.48m 2 Overlay™ Lite oor pan…

9, Pre-installation requirements The sub oor must be swept clean and be free from mortar residues. Installation Laying the floating floor panels Step 1: Lay the 1200 x 1200 x 50mm oating oor panels directly over the entire oor area to be heated, ensuring the panel grooves are alig…

13, Designing your layout Designing the ideal room layout for an MHP installation and selecting the required products couldn’t be simpler. Follow the steps below or use the online product selector tool at www.ufch.com/mhp Select panel width Step 1: The spacing of joists and the available gap w…

22, 42 43 Programmable room thermostats Programmable Room Thermostat PBPRP: The PBPRP remote programmable room thermostat is a battery operated unit and offers the following outstanding features: • 24 hour / 7 day time and temperature control • Optimised system start • Set…

5, 08 09 SYSTEM SELECTION Our comprehensive system design service includes: • System design, including heat loss calculations for residential applications • Circuit lengths • Circuit pressure losses and velocities • Flow rate settings per circuit • Full product material speci…

11, 20 21 Pipe only systems The use of heat spreader plates is recommended, as they assist the response time and heat dispersion. However, in some circumstances, simply laying pipe in an air void between foil faced reective insulation and the underside of the oorboard will be ade…