Planteko Diamond Operation & User’s Manual

2, Buoyancy compensator DIAMOND - User manual Denition of terms Buoyancy compensator – a device for adjusting buoyancy, consisting of a wing and a harness (picture 1). Wing – a part of the buoyancy compensator consisting of a bladder, ination mechanism, and safety valve. Harne…

3, Fitting the harness (pictures 4 & 5) 1. Set the length of the rear center strap so that the top plate is between the shoulder-blades and the bottom plate bellow the sacrum, the side straps then lead across the buttocks. 2. Adjust the shoulder straps so that the harness will t well on the…

4, 8. Optional weighting system large (picture 10), weighting system small (picture 11) and trim pockets (picture 12). Thread the rear center strap of the harness, then through the tunnel in the weighting system and again through the bottom plate. The same procedure applies for the side parts. Trim…

5, Regulators & hoses Left bottle - the 1st stage can be non-slewing, up from it leads LP hose towards the 2nd stage and inator hose. The inator hose may pass over the shoulder or under arm, recommended length is 45-55 cm. The LP hose runs under the arm around the neck and 2…

6, Planteko Diamond Inspections We recommend doing the inspection described above before every use. We highly recommend having a thorough inspection performed once a year by factory trained personnel. Compensator description Back plates: The material is stainless steel. Wing inner bladder: The material is …