Pix Controller DigitalEye Instruction Manual

11, Pix Controller DigitalEye Step 4 Lock the Master Lock Python Cable to the tree and remove the key. Step 5 Your DigitalEye™ 7.2 camera system is now firmly locked to the tree and ready to take photos. Checking your DigitalEye™ 7.2 Unit When checking your DigitalEye™ 7.2 unit it’…

13, Problem Solving Tips and FAQ’s Problem/Question Answer Why is there sometimes nothing in my photo? Sometimes birds can fly past your camera setup and trigger the camera. A bird flying past can be too fast for the camera to catch. You may also have a “false photo”. Sometimes…

6, Delays Between Pictures Setting Switches 1, 2, and 3 control the delays between pictures. *Trail Mode™ 10 Seconds Delay 30 Seconds Delay 1 Minute Delay 2 Minu…

12, Step 2 Unplug the camera cable. Note: be sure the camera is turned off and the unit power switch is turned off before unplugging the camera cable. Note: Pull straight down, do not twist cable. Note: Pull straight down, do not twist cable. Step 3 You can now remove the dig…

14, The DigitalEye™ 7.2 Built-In Low Battery Indicator When the batteries do not have sufficient charge, the DigitalEye™ 7.2 Green PIR LED will start blinking about once every ½ second. When this occurs it is time to replace the 9V Battery. Turn the “Unit Power Switch” to the off positi…

7, PIR Walk-Test Mode On boot up of the DigitalEye™ 7.2 this setting will put the unit into a PIR Walk-Test mode. Here you can check out the PIR detection area without having the unit take photos. When booting the DigitalEye™ 7.2 into this mode the RED Control LED and Green …